(1) If the adjustment of the tension of the triangular tape is checked regularly, the requirements cannot be met and the new triangular tape must be replaced. When replacing, all the belts on the same pulley should be replaced at the same time. Otherwise, the length of the belt will be uneven due to the difference between the old and the new, resulting in uneven distribution of the load on the V-belt, causing the vibration of the V-belt, the transmission is not stable, and the work of the V-belt transmission is reduced. effectiveness.
(2) During use, the operating speed of the V-belt should not exceed 60 °C. Do not apply belt grease. If the surface of the V-belt is illuminated, it indicates that the V-belt has slipped. First remove the dirt on the surface of the belt and apply a proper amount of belt wax. Use warm water when cleaning the V-belt. Do not use cold water or hot water.
(3) For all types of V-belts, it is not advisable to apply rosin or sticky substances, but also to prevent contamination of oil, butter, diesel and gasoline, otherwise the V-belt will be corroded and the service life will be shortened. The groove of the V-belt should not be oiled, otherwise it will slip.
(4) When the V-belt is not in use, it should be kept in a place where the temperature is relatively low, there is no direct sunlight and no oil and corrosive smoke to prevent it from deteriorating.